i installed an amp for a subwoofer on my stock system, everything wired cleanly in the center console area, amp under passenger seat. I used a line out converter to transfert the high output signal to low output but i am now getting any positive signal from the LOC only ground and everything was wired according to the wirning diagram on the download section (rear speaker wires used). everything was soldered then taped over, could the LOC be defective or im just bad at it ? (the LOC ground is connected to the radio frame, i was now sure if it is proper)
the amp isnt powering??? if its not its the same thing that happened with my car u have a defective battery go get a low test done to check n make sure
Hey whats up! I did a similar thing as well but i did not use the ground wire on the LOC i just cut that wire right off. It may work if you try it like that.
i will try cutting the LOC ground amp is powering , everything is pluged in nicely, just no signal coming from the RCA :?
