/ Register

need help asap

Discussion in '8G Lancer - Performance' started by dogdog130, May 28, 2009.

  1. dogdog130

    dogdog130 Well-Known Member

    i got the rrm pully well i trying to take off the crank pully when i turn the gun on the pully turns how do i stop that
     
    dogdog130, May 28, 2009
    #1
  2. Eric1180

    Eric1180 Active Member

    never done the pully yet but are you sure it does not have reverse threads
     
    Eric1180, May 28, 2009
    #2
  3. dogdog130

    dogdog130 Well-Known Member

    TRYED BOTH WAYS
     
    dogdog130, May 28, 2009
    #3
  4. Eric1180

    Eric1180 Active Member

    Eric1180, May 28, 2009
    #4
  5. dogdog130

    dogdog130 Well-Known Member

    see i watched that and it didnt turn for hem
     
    dogdog130, May 28, 2009
    #5
  6. Prophet

    Prophet Well-Known Member

    Check the setting on your impact gun. It may not be turning fast enough...
     
    Prophet, May 28, 2009
    #6
  7. colt_racer

    colt_racer Member

    Yeah.. your impact gun has to turn with a little more than 155 lbs of torque to loosen it. hopefully your trying with an air powered gun, and not an electric impact gun. because sometimes electrics don't seem to output the amount power that they are supposed to. You can try this by KD tools. part number 41530

    http://www.napaonline.com/NOLPPSE/(S(xq ... 55saggw43b))/Results.aspx?Ntt=41530&Ntk=Part%20Number&N=0&Nty=1&D=41530&Dn=0&Dk=1&Dp=3
     
    colt_racer, May 28, 2009
    #7
  8. dogdog130

    dogdog130 Well-Known Member

    yea i will try agin tomorrow it rained its ass off so i had to pack all my shit up but try agin in the morning
     
    dogdog130, May 28, 2009
    #8
  9. johntango

    johntango Active Member

    Yah are you using the electric impact gun??? Coz i'm going to do this mod to and I only have an electric impact gun that weights a ton.
     
    johntango, Jun 3, 2009
    #9
  10. dogdog130

    dogdog130 Well-Known Member

    no air impact gun i had to get a better gun to do it mine wasnt adnofe torq to do so
     
    dogdog130, Jun 3, 2009
    #10
  11. bras_33

    bras_33 Well-Known Member

    air impact gun will do it, electric is a joke and a waste of money. If I am not mistaken, I think its reversed butt then again its been so long since I did that. also check the how to thread on here.
     
    bras_33, Jun 3, 2009
    #11
  12. dogdog130

    dogdog130 Well-Known Member

    mine was regulater just my 600 targ wasnt good adnofe had to get 1200
     
    dogdog130, Jun 3, 2009
    #12