Angel Eyes Finally Installed...!!! *PICTURES*

Finally they are on!

although fern broke, not one, but TWO rings (the ones that were supposed to be on the high beams), we managed to install the low beams. It was a long night, but as always, we had a blast. my boy Eric (Automoglow) is da shit....

on with the pix


- Trying to figure out how to install it



- "Should we put it like this?......"



- ".....or like this?"



- One of the 2 rings pimpinfern broke *sigh*



- Test



- Drilling the hole to fit the cables... Really easy with a dremel drill or how ever you call it.



- Once the connector clears the hole, you are done...



- We panted the cables black cause fern has the blacked out housing... On a chrome housing, it would look fine...



- Baked back together



- Due to the low light environment, it was impossible to take far away pictures that you could see the ring... We are going to take some pics in the late afternoon so you can see it better



- Close up, lights off



- Close up, lights on



Thats it for now

We are waiting on another set to do it on my car.. this time ill make sure fern doesnt break the small rings :twisted:

I was going to do a How-To, but i think its not necessary cause its all common sense... if anything, the only thing that you could use help is baking the headlights and tearing them apart... other than that, the rings come with double face tape so its easy to install, drill the holes for the cables, and wire them however you want... I wired them to one of the 3 lil spots on the left side of the steering wheel, to a lil autozone switch... I will not explain the wiring due to liability issues. If you dont know how to wire it, its best for you to seek professional help...

hope you guys like it

 

Bake..
in our case we did bake @ 250 degrees for 5 mins each... the rest is all muscle lol

 

I dont see any interest in them here though.. this might not even go thru...

with demand, comes supply

 

Lets not get off topic here please...

the kit will OBVIOUSLY bring instructions, thats common sense... what i meant is that there is no sense in writing a how to right now when there arent even available yet. we will get together and write some instructions and they will be sent out with the kit... I dont think a public how to on this would be necessary.

also they are meant for both high and low beams, but fern broke both the high beam's rings :roll:

whenever we get the V1.1 of these, ill install them in my car. that install will be more close to everybody's car: chrome headlights and never before opened headlights....